Uses the 3DES or DES encryption algorithm to calculate the MAC.
Start MAC calculation from step 1 or 2 as follows:
- To calculate the MAC for line packets, start from Step 1.
- To calculate the MAC for fixed data of a specific app, start from Step 2.
- Calculate the MAC for line packets.
- Create an initial variable by concatenating a 4-byte random number and 00 00 00 00.
- Perform the calculation.
Concatenate the following data to form a data block:
Lc is the actual length of the data field in the instruction sent by the device, including the length of the 4-byte MAC.
- Plaintext or ciphertext data contained in the data field in the instruction.
- Calculate the MAC for fixed data of a specific app.
- Use the 8-byte 00 00 00 00 00 00 00 00 as the initial variable.
- Perform the calculation.
Concatenate the fixed data of a specific app to form a data block.
- Split the data block generated into smaller 8-byte data blocks, and number them as D1, D2, D3, D4, and so on. Note that the last block may contain 1 to 8 bytes.
- Pad the last data block to 8 bytes.
- If the last data block contains 8 bytes, you still need to add the hexadecimal number 80 00 00 00 00 00 00 00 to the end of the block.
- If the last data block contains less than 8 bytes, add the hexadecimal number 80 to the end of the block. If the number of bytes is still less than 8, add the hexadecimal number 00 until the block contains 8 bytes.
- Encrypt the 8-byte data blocks using the application maintenance key (AMK) and 3DES algorithm, as shown in Figure 1.
The number of 8-byte data blocks encrypted in this step depends on the length of the data block formed in step 1 or 2. MAC is the first four bytes from the left of the last 8-byte data block that is encrypted.
Figure 1 SM-MAC algorithm using a double-length DEA key
- I: input
: XOR operation
- O: output
- DEA (e): data encryption mode
- D: data block
- DEA(d): data decryption mode
- KMA: left 8 bytes of the double-length key
- KMB: right 8 bytes of the double-length key